Vacuum Creation; Stopping Of Packaging Cycle; Use Of The Packaging Machine Only As A Sealer - Vollrath Junior Mode D'emploi Et D'entretien

Table des Matières

Publicité

JUNIOR
EN

VACUUM CREATION

3.3

STOPPING OF PACKAGING CYCLE

If the packaging cycle has to be stopped for any reason, (suction of liquids, bag not correctly positioned, etc.) carry out the following:
• Press the button (1) "ON/OFF" to stop the appliance.
• Press the button (1) "ON/OFF" again to release the movable lid (A - Fig. 2).
3.4

USE OF THE PACKAGING MACHINE ONLY AS A SEALER

• Connect the appliance to a power socket.
• Switch the machine on by pressing the button (1) "ON/OFF" until all the lights on the buttons come on briefly.
• Adjust sealing intensity according to the thickness of the bag by pressing the button "SEAL TIME" (for very thin bags select the smallest LED (1);
select the largest LED (4)) for thicker bags.
• Select the manual mode by pressing the button "MANUAL" (LED on).
• Lift the machine lid (A).
• Place the opening of the bag containing the product to be packed on the sealing bar (B).
• Lower the movable lid of the appliance, select manual mode by pressing the button "MANUAL"
and lightly press down on the lid.
• After 3-4 seconds press button "SEAL". The machine will seal the bag and automatically
stop afterwards.
When finished using the machine, press "ON/OFF". Unplug the
machine to completely disconnect the power supply.
1
Operating and service manual / Mode d'emploi et d'entretien
Manual de uso y mantenimiento / Ed. 10 - 2015
Fig. 2
1 2 3 4
20
CONDITIONNEUSE SOUS VIDE
A
A
B
VACUUM PACKING MACHINE
MAQUINA DE VACÍO
REV. 04 - Cod.: 1500387

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Junior

Table des Matières