Table des Matières
Publicité
JUNIOR
EN
TROUBLESHOOTING
6.
TROUBLESHOOTING
PROBLEMS
- LEDs do not come on.
- Insufficient vacuum in bag.
- Inefficient pump (only for machines
equipped with filter).
- The quality of sealing gets worse.
Operating and service manual / Mode d'emploi et d'entretien
Manual de uso y mantenimiento / Ed. 10 - 2015
CAUSES
No power supply.
Damaged power cord.
Blown fuse.
Damage to the vacuum packaging machine.
The bag leaks.
Sharp edges perforate the bag.
Bag opening dirty.
Liquids sucked during vacuum creation.
Sealing bar dirty.
Bar covering Teflon strip worn.
26
VACUUM PACKING MACHINE
CONDITIONNEUSE SOUS VIDE
SOLUTIONS
Insert the plug in a suitable power socket.
Check the condition of the power cord.
Make sure fuse (A) is correctly fitted and not
blown.
Contact an authorized assistance centre.
Contact the Technical Assistance Centre.
Change the type of bag.
Use thicker bags.
Use a new bag, make sure to keep the opening
clean.
Empty and clean the filter on machines fitted
with that accessory; contact an authorized
assistance centre.
Clean the sealing bar .
Replace the Teflon strip. Contact an authorized
assistance centre.
A
•
REV. 04 - Cod.: 1500387
MAQUINA DE VACÍO
Publicité
Table des Matières
