Olimpia splendid DOLCECLIMA Mode D'emploi Et D'entretien page 48

b. This mode is similar to cooling mode, except that:
fan speed selection not active (Set temperature) set equal to "Tamb" (ambient temperature).
c. In dehumidification mode only, the appliance can operate with only the condensate drain pipe connected
(12) and without the flexible air expulsion hose.
3.8 - AUTO MODE (Automatic)
a. This mode can be selected by pressing B2 or SW2 until the automatic symbol (AUTO/ D2) is displayed
on the remote control.
b. In this mode, the COOLING and FAN functions are selected automatically depending on the continuously
monitored room temperature value to ensure that there is a perfect comfort-level in the conditioned room.
3.9 - NIGHT FUNCTION
a. This mode can only be selected from the remote controller by pressing the B4 key, the symbol D11 appears
on the display; this mode can only be used combined with cooling and automatic modes.
b. When this mode is enabled, the internal fan is forced to run at automatic speed and the set room temper-
ature is automatically increased by 1°C after 1/2 hour and by another 1°C again after 1/2 hour (starting
from function activation and consequent modification of the set temperature).
c. After 7 hours the initial temperature is automatically restored.
d. When the set temperature is modified from the remote control, when the appliance is placed in standby,
or when the power supply is disconnected, the night function is disabled.
e. To deactivate the function press the B4 button again.
3.10 - TIMER MODE
a. This mode allows to program the switching on or the switching off of the appliance.
b. The delay time can be set by the remote control.
3.10.a - Programmed switching on
Select the operating mode, the desired temperature and the ventilation speed with which the unit will
activate automatically as programmed.
a. By pressing B9, set the desired time delay (from 0.5 to 24 hours) after which the unit will switch ON (starting
from timer confirmation).
If no button is pressed within 5 seconds the timer setting function will terminate automatically.
b. When the delay time set has elapsed, the unit switches ON with latest selected settings.
c. To cancel the delayed power-on, press button B9 again until a value of 0 is set.
d. When the timer is active, symbol D14 is activated on the machine and symbol 7 on the remote control.
3.10.b - Programmed switching off
a. With the unit in any working mode, press B8 to set the desired time delay (from 0.5 to 24 hours) after
which the unit will switch OFF (starting from timer confirmation).
Each following B8 key operation increases the delay time value by 1 hour.
b. If no button is pressed within 5 seconds the timer setting function will terminate automatically.
When the delay time set has elapsed, the overall unit switches OFF.
c. To cancel the delayed shutdown, press button B8 again until a value of 0 is set.
d. When the timer is active, symbol S2 is activated on the machine and symbol D13 on the remote control.
3.11 - SETTING THE UNIT OF MEASUREMENT OF TEMPERATURE
On pressing buttons SW3 SW4 simultaneously for 3 seconds you can change the temperature unit of
measure indicated on the machine display from CELSIUS (°C) to FAHRENHEIT (F) and vice versa.
EN - 16