Adjusting Air Shutter
1. Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See Pivot Point in figure.
• Gas valve and orifice hood are visible after burner
control panel is removed.
A
D
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
Burner Control Panel
4. Slide air shutter open or closed depending on
appearance of burner flame.
• If flame is yellow and does not hold its shape, open
air shutter.
• If flame is blowing or noisy, close air shutter.
5. Reassemble burner control panel.
Adjusting Air Shutter
All manuals and user guides at all-guides.com
B
C
Close
Open
Test and Adjust Oven Burner Flame
Turn on oven burner. See "Baking" section for oven burner
operating instructions. Properly adjusted oven burner
flames are blue with a distinct deep blue inner cone
approximately ½ inch long. When using natural gas,
flame should not have any yellow flame when burning.
Some yellow flame when burning LP\propane gas is
normal.
Flame should not be visible in the oven cavity when
burning and should not extend into the oven cavity beyond
the removable oven bottom.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner.
Adjust Oven Burner Flame
1. Check that oven temperature knob is in OFF position.
2. Open broiler door and remove broiler pan, grid, and
rack.
3. Through rectangular hole in rear of broiler cavity,
loosen air shutter lock screw and open or close air
shutter.
• Tighten air shutter lock screw after adjusting.
A
B
A—Air Shutter Lock Screw
B—Air Shutter
Adjust Oven Burner Air Shutter
4. Repeat test if necessary.
5. Replace broiler pan, grid, and rack.
14
Open
Close