Publicité
Les langues disponibles
Les langues disponibles
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1
1. Measure 3
/
inches from back wall on right and left
2
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
1
line drawn 3
/
inches from back wall and side of
2
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
or
Anti-tip Bracket Location
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. After range is slide into position, verify the range
leveling leg has engaged anti-tip bracket.
All manuals and user guides at all-guides.com
3 1/2"
3
/
inch drill bit.
32
3
/
inch masonry drill
16
11
Verifying anti-tip bracket position
1. After range is in place, open broiler door and remove
broiler rack, pan, and grid.
2. Remove screws in front of broiler area on side of
range that antitip bracket is installed.
3. Remove panel and look towards back of oven and
check anti-tip bracket has engaged leveling leg.
4. Reinstall panel after checking anti-tip bracket.
Remove
Screws
Verify Anti-tip Bracket Position
Gas Connection
Connect gas supply to regulator using hard pipe or flexible
connector (Check local codes). Pressure regulator
supplied with this appliance has a ½ inch NPT female
connection. If gas union is used, remove storage drawer,
slide range into place, and connect union.
• A manual shutoff, not supplied with range, must be
installed in an accessible location outside of range.
• Use joint compound that is resistant to action of
propane gas on all male pipe threads.
• Use supplied pressure regulator only.
• Do not overtighten gas fitting when attaching to
pressure regulator. Overtightening may crack regulator.
• Support pressure regulator with wrench when installing
gas fitting.
Remove
Panel
Publicité
