Toro HDX SD 2000 Serie Manuel De L'utilisateur page 62

1. Blades front to rear
2. Blade tip
8. Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9. Place 2 blocks (see table below) under the rear
edge of the cutting deck skirt; 1 on each side of
the cutting deck
10. Set the height-of-cut lever to the 3 inch (76 mm)
position.
11. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
Bottom view
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
Deck Size Block Height
All mower 7.3 cm (2.87 inches)
decks
12. Carefully rotate the blades side to side
81).
Figure 82
3. Measure from the tip of the
blade to the flat surface
here.
(Figure 83).
Figure 83
2. Welds
Rake
4.8 to 6.4 mm (3/16 to 1/4
inch)
13. Loosen the locknuts
and ensure that the mower deck is sitting
securely on all 4 blocks.
14. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
15. Tighten the 4 locknuts.
g229304
1. Locknuts
2. Deck-lift arm
16. Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
17. Continue leveling the deck by checking the
front-to-rear blade slope.
18. Check the blades for levelness and repeat deck
leveling procedure if necessary.
Removing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
g038090
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Place the height-adjustment pin in the 7.6 cm (3
inch) cutting-height location.
4. Remove the belt covers.
5. Loosen the mower deck idler and remove the
mower belt; refer to
6. Remove the bolts and nuts from the front of the
plate under the footrest.
(Figure 7. Remove and retain the bolts and nuts on both
sides of the machine
60
(Figure 84) on all 4 corners
Figure 84
3. Deck hanger
4. Chain
Belt Maintenance (page
(Figure 85).
g035851
49).