Toro HDX SD 2000 Serie Manuel De L'utilisateur page 30

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
(also the 127 mm or 5 inch cutting-height
position) as shown in
3. Remove the pin from the height-of-cut bracket
(Figure 29).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
Figure 29
1. Deck-lift pedal
2. Height-of-cut holes
position.
OCK
position
RANSPORT
Figure 29.
29).
3. Height-of-cut pin
4. Transport lock knob
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
30.
1. Anti-scalp roller
2. Spacer
3. Bushing
g036745
1. Flange nut
2. Bolt
3. Bushing
28
Figure 30
4. Flange nut
5. Bolt
Figure 31
4. Anti-scalp roller
5. Spacer
Figure
g192815
g036848