Toro HDX SD 2000 Serie Manuel De L'utilisateur page 50

Figure 58
1. Cotter pin
2. Parking brake
7. Check both spring lengths as shown in
59. If an adjustment is necessary, turn the
top nut clockwise to shorten the spring and
counterclockwise to lengthen it.
Figure 59
1. Top nut
2. Spring
8. Push the parking brake lever all the way forward
and down.
g036752
3. Brake linkage shaft
Figure
g036100
3. 44 mm (1-3/4 inches)
9. Rotate the brake-linkage shaft until the end
aligns with the hole in the lever.
•
Shorten the linkage by turning it clockwise.
•
Lengthen the linkage by turning it
counterclockwise.
10. Insert the brake-linkage shaft into the
parking-brake hole and secure with the cotter
pin. Repeat step
11. When adjustment is complete, remove the jack
stands or equivalent support and lower the
machine.
12. Place the machine into the O
Refer to Using the Drive-Wheel Release Valves
(page 30).
48
5 and adjust if necessary.
position.
PERATING