Toro HDX SD 2000 Serie Manuel De L'utilisateur page 37

Removing the Sheet-Metal
Guard
Loosen the 2 front bolts and remove the sheet-metal
guard to access the mower belts and spindles
(Figure 38). After performing maintenance, install the
sheet-metal guard and tighten the bolts.
Figure 38
1. Sheet-metal guard
g192921
2. Bolt
Lubrication
Greasing the Machine
Service Interval: Every 25 hours—Grease the front
caster axles. (more often in dirty or
dusty conditions).
Every 50 hours—Grease the pump-idler pivot.
Grease the machine more often in dirty or dusty
conditions.
Grease Type: No. 2 lithium or molybdenum grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake; refer to
(page 23).
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
4. Grease the pump idler-pulley pivot with 1 or 2
pumps of grease
5. Grease the front caster axles
1. Pump-idler pivot
6. Wipe up any excess grease.
35
Operating the Parking Brake
(Figure 39).
(Figure 39).
Figure 39
2. Caster axle
g188563