Ryobi RLT430CES Manuel D'utilisation page 21

EN
FR DE ES
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
INSTALLING THE POWER HEAD SHAFT TO THE
ATTACHMENT
See Figure 2.
WARNING:
Never install, remove, or adjust any attachment
while the power head is running. Failure to stop
the engine can cause serious personal injury.
The attachment connects to the power head shaft by
means of a coupler device.
Loosen the Wing Screw on the coupler of the
Q
power head shaft and remove the end cap from the
attachment.
Push in the button located on the attachment shaft.
Q
Align the button with the guide recess on the power
head coupler and slide the two shafts together.
Rotate the attachment shaft until the button locks into
the positioning hole.
NOTE: If the button does not release completely in
the positioning hole, the shafts are not locked into
place. Slightly rotate from side to side until the button
is locked into place.
Tighten the knob securely.
Q
WARNING:
Be certain the Wing Screw is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious personal
injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
For removing or changing the attachment:
Q Loosen the knob.
Push in the button and twist the shafts to remove and
Q
separate ends.
IT PT NL SV DA
English (original instructions)
NO FI HU CS RU
ATTACHING THE STORAGE HANGER
See Figure 3.
There are two ways to hang your attachment for storage.
To use the hanger cap, push in the button and place
Q
the hanger cap over end of the lower end attachment
shaft. Slightly rotate the cap from side to side until the
button locks into place.
The secondary hole in the attachment shaft can be
Q
used for hanging purposes as well.
ATTACHING THE FRONT HANDLE
See Figure 4.
Remove the clamp and bolts from the front handle.
Q
Q Install the front handle onto the top side of the drive
shaft boom with the barrier bar on the same side as
the recoil starter (compare to product images in figure
sheet or on giftbox)
Place the bolts through the front handle.
Q
NOTE: The hex bolt head fits inside the hex recess
moulded into one side of the handle.
Reinstall the clamp.
Q
Q Tighten bolts securely.
WARNING:
The line cutting blade on the grass deflector is
sharp. Avoid contact with the blade. Failure to
avoid contact can result in serious personal injury.
ATTACHING THE GRASS DEFLECTOR
See Figure 5.
1. Assembling the grass deflection into the tab on the
drive shaft and make sure the bolt complete into the slot
of the tab.
2. Use the wrench to tighten the nut securely with
clockwise.
OPERATION
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating power tools. Failure to
do so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
18
RO PL SL HR ET LT LV SK BG