Flex L 3709-115 Notice D'instruction D'origine page 20

Operating instructions
t^okfkd>
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that there
are no missing or damaged parts.
Switching on and off
Brief operation without engaged
switch rocker:
 Depress switch rocker (6) at back, then
push forwards and hold.
 To switch off the power tool, release
the switch rocker (6).
Continuous operation with engaged
switch rocker:
`^rqflk>
Ei=PTMVJNNRI=i=PTMVJNORI=
i=NMJNM=NORF
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇJçå=
ã~ÅÜáåÉ=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 Depress switch rocker (6) at back, then
press forwards and engage by pressing
on the front end.
20
L 3709-115, L 3709-125, LE 9-10 125, L 10-10 125
 To switch off the power tool, release the
switch rocker (6) by pressing the rear end.
Speed preselection
(LE 9-10 125 only)
To set the operating speed, move the dial (10)
to the required value.
Safety guard
(L 3709-115, L 3709-125)
t^okfkd>
kÉîÉê=ïçêâ=ïáíÜçìí=íÜÉ=ë~ÑÉíó=Öì~êÇK
The angle grinder is adapted to the job with
the safety guard (2) which can be adjusted
without a tool.
A special cutting guard must be used
for cutting.
`^rqflk>
oáëâ=çÑ=áåàìêó>=tÉ~ê=éêçíÉÅíáîÉ=ÖäçîÉëK
 Pull out the mains plug.