Flex L 3709-115 Notice D'instruction D'origine page 21

L 3709-115, L 3709-125, LE 9-10 125, L 10-10 125
 Rotate safety guard to the required
position.
Quick-release guard
(LE 9-10 125, L 10-10 125)
t^okfkd>
tÜÉå=ìëáåÖ=íÜÉ=~åÖäÉ=ÖêáåÇÉê=Ñçê=êçìÖÜáåÖ=
çê ÅìííáåÖI=åÉîÉê=ïçêâ=ïáíÜçìí=íÜÉ=Öì~êÇK
 Pull out the mains plug.
 Loosen the clamping lever (a).
 Adjust the guard.
 Tighten screw (b) until the clamping lever
can just be clamped by hand.
 Retighten the clamping lever.
 A special quick-release cutting guard must
be used for cutting.
Attaching or changing the grinding
tool
 Pull out the mains plug.
 Press and hold down the spindle lock (1.).
 Using the stop key, loosen the clamping
nut on the spindle in an anti-clockwise
direction and remove (2.).
 Insert the grinding wheel in the correct
position.
 Screw the clamping nut (1b), with flange
face up, onto the spindle.
 Press and hold down the spindle lock (4).
 Tighten the clamping nut (1b) with the
stop key.
 Insert the mains plug into the socket.
 Switch on the angle grinder (without
locking into position) and leave the angle
grinder running for approx. 30 seconds.
Check for imbalances and vibrations.
 Switch off the angle grinder.
21