Flex L 3709-115 Notice D'instruction D'origine page 19

L 3709-115, L 3709-125, LE 9-10 125, L 10-10 125
 Support plates or large workpieces
to prevent the risk of a kickback due
to the cutting-off wheel jamming.
Large workpieces may sag under their own
weight. The workpiece must be supported
on both sides of the wheel, namely near
the separating cut and along the edge.
Additional safety instructions:
 The mains voltage and the voltage speci-
fications on the rating plate (9) must
correspond.
 Do not press the spindle lock (4) until
the grinding tool stops.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
Sound pressure
level dB(A)
Sound power
level dB(A)
Uncertainty
K (dB)
Total vibration value (when sanding surfaces):
Emission value
2
a (m/s )
h
Uncertainty
2
K (m/s )
L 9-10 L 3709 L 10-10
125 125
87 84.6 91
98 95.6 102
3 3
L 9-10 L 3709 L 10-10
125 125
6.5 6.5 6.6
1.5 1.5 1.5
Total vibration value (when cutting):
Emission value
a (m/s
h
Uncertainty
K (m/s
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure. The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different appli-
cations, with different accessories or poorly
maintained, the vibration emission may differ.
This may significantly increase the exposure level
over the total working period.
For a precise estimation of the vibration load the
times should also be considered during which
the power tool is switched off or even running,
3
but not actually in use. This may significantly
decrease the exposure level over the total
working period. Identify additional safety
measures to protect the operator from the
effects of vibration such as: maintain the tool
and the accessories, keep the hands warm,
organisation of work patterns.
tÉ~ê=É~ê=éêçíÉÅíáçå=~í=~=ëçìåÇ=éêÉëëìêÉ=
~ÄçîÉ=UR=Ç_E^FK
L 9-10
125
8.1
2
)
1.5
2
)
t^okfkd>
klqb
`^rqflk>
L 3709 L 10-10
125
6.3 6.2
1.5 1.5
19