Publicité
Les langues disponibles
Les langues disponibles
The system is able to encode normal CD/Turntable/DAB radio...etc to MP3 format and
recording at memory media with USB connecting port (or SM/MMC card slot). Before starting
the encoding, please insert the memory media (USB pen drive or SD/MMC card) to the system
& make sure it had adequate free memory size for recording:
A) CD encoding
I) Encoding 1 track
1. Perform normal playback of the CD track you want to encode.
2. Press "
" button during the playback of the desire track and the system will show
"REC_ONE" for a while.
3. Then display will change to show "REC>>CARD" or "REC>>USB" and flashing. Encoding is
performing now, the selected CD track will start to play as well.
4. After completing of recoding, unit will stop playback automatically.
II) Encoding whole disc
1. Stay at CD stop mode by press " / ENTER" button.
2. Press "
" button the system will show" REC_ONE" for a while.
3. Press "
" again and the unit will show "REC_ALL".
4. Then the system will show "REC>>CARD" or "REC>>USB" and flashing. Encoding is
performing now, the whole CD will start to play as well.
5. After completed whole disc recoding, unit will stop playback automatically.
III) Encoding by program
1. Place a CD with the printed side facing up inside the tray & then close the co door.
2. Select the desire tracks by following "CD disc programming " procedures 2-4. Then press
" / ENTER" button to stay in stop mode with program memory.
3. Press the "
4. Then the system will show "REC>>CARD" or "REC>>USB" and flashing. Encoding is
performing now, the programmed CD tracks will start to play as well.
5. After completing of encoding according to the program memory, unit will stop playback
automatically.
Remark:
-
Same operation procedure for encoding to SD/MMC card.
-
If both recoding source (USB pen drive and SD/MMC card) being detected by the system
during encoding, please press "
Then press "
-
The recording speed is 1:1 and according to the actual plying time of the CD track
The system will create a "audio" folder and then store the encoding track in it.
-
The recording format is preset at – MP3 bit rate: 128 kbps, sampling rate: 44.1khz
-
-
No song title will be recorded during encoding mode
To interrupt the recording, press the " / ENTER" button during recording mode.
-
-
Recording will be completed only entire song being encoded, if terminate the encoding
process intermediately, there is no track being recorded nor stored to the USB or SD/MMC
card.
ENCODING
" button and the unit will display "REC_ALL" for a while
TUNE –" or "
" button again to continuous the process.
MCD1820 / English Instruction Manual
TUNE +" to select the desired source.
8
Publicité
