Tunturi CARDIO FIT B30 BIKE Manuel De L'utilisateur page 16

English
Adjusting resistance
To increase or decrease resistance, turn the adjustment knob at
front of the rowing frame cover clockwise (+ direction) to increase
resistance and Counterclockwise (- direction) to decrease resistance.
The scale above the knob (1-8) helps you find and reset a suitable
resistance.
Replacing the batteries (Fig E )
The console is equipped with 2 AA batteries at the rear of the
console.
Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that batteries match the (+) and
(-) polarity markings.
- Mount the cover.
Console (fig E-1)
1
3
2
1. Display
2. Tablet/ book support
3. Buttons
⚠ CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered with drops of
sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes.
Explanation Display functions
Scan
Automatically scan functions for : Time, Speed, ODO, Dist, RPM &
Cal.
Each display will be hold 4 seconds
Time
Automatically accumulates workout Time when exercising.
Speed
- Displays current training speed.
Odo
Automatically accumulates the Total distance for all exercise sessions.
Dist
Distance for the workout.
- M Indicates parameters in meter.
Pulse
Display current heart rate if measured.
‼ NOTE
• Before measuring your pulse rate, please place your palms of
your hands on both of your contact pads and the monitor will
show your current heart beat rate in beats per minute(BPM) on
the LCD after 6~7 seconds.
• During the process of pulse measurement, because of the
contact jamming, the measurement value may be higher than
the virtual pulse rate during the first 2~3 seconds, then will
return to normal level.
• The measurement value cannot be regarded as the basis of
medical treatment.
Cal
Automatically accumulates Calorie burnt when exercising.
‼ NOTE
• This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment
Explanation of buttons
MODE
- Press MODE button to select console functions; Time, Speed, Dist,
ODO, Cal. & Pulse
- Push and hold for 4 seconds to reset: Time, Count, Dist & Calorie.
SET
Set the values for: Time, Count, Dist & Calorie when not in scan
mode.
- Press SET button to set console in goal input mode.
- Press MODE to select goal you like to set. (the selected goal will
blink when able to set value.)
- Press SET Button to higher the goal input, hold SET button to
higher the value fast.
- Press RESET button shortly to reset the changed selected goal.
- Press MODE Button to active next optional goal to be set.
TIME + 1 min
SPEED
DIST + 0,5KM ( 0,5KM ~ 99,50Km )
ODO
CAL + 1
PULSE + 1
‼ NOTE
• When you set a goals the set goal value will Count down in
active mode.
• When goal is reached the console will notify by 4 dual acoustic
beep signals. The reached value will now Count up starting from
"0".
• You can set more than one goal, all goals will notify when goal is
reached.
RESET
- Push and hold for 4 seconds to reset: Time, Dist., Cal., & Pulse
‼ NOTE
• Total Count can only be reset by a batteries exchange.
1 6
( 1 ~ 99)
( max. 99,9 Km/h)
( max. 999,9 Km)
( 1 ~ 999 )
( 40 ~ 240 )