Ope Ra Ti On - Ammann APH 5020 Traduction Du Mode D'emploi Original

3.6 Op er a tion
Un der ad verse con di tions start-up of the ex citer may
be im peded. Then the en gine can not reach its nom i nal
RPM. This can be rem e died by ac ti vat ing the drive le -
Important
ver (2) sev eral times.
b
a
2
• Set the speed le ver (1) in full load di rec tion.
To avoid cou pling dam ages, take care that the mo -
tor speed of the ma chines with cen trif u gal
clutches are clearly above or resp. be low the start -
Attention
ing speed (about 1200 rpm).
The mo tor has to cut-off by long work ing breaks;
long idle-runnings can take to great mo tor dam -
ages.
• Ad just the drive di rec tion and speed at the drive le ver (2).
• Guide and steer the ma chine at the tow bar; the op er a tor
should go along side the tow bar.
For com pac tion of pav ing stones, it is rec om mended
to use Vulkollan plates and pro tec tive brack ets (spe -
cial ac ces so ries) to pre vent dam ages to the com pac -
Important
tion ma te rial and to the machine.
If the ma chine is used with out pro tec tive bracket, the
threaded fas ten ings in the base plate must be sealed
with the sup plied screw plugs .
3
1
II
0 I
B3w99002.cdr
38

3. Ope ra ti on