Mechanical Assembly - Pilz PSEN op2 Série Manuel D'utilisation

Operating Manual

3. MECHANICAL ASSEMBLY

The transmitter (TX) and receiver (RX) must be
assembled so that the respective optical
surfaces are arranged parallel to each other and
the connectors are positioned on the same side.
The distance between the transmitter and
receiver must be within the operating range of
the model you are using (see type label or Ch.9,
"Technical details").
Align the devices precisely, following the
guidelines given in Ch. 5, "Alignment".
Use the supplied angle bracket to attach the
device, as shown in Fig. 12.
Depending on the application, both rails may either be screwed on
using the fixing bolts supplied or by using a rigid mounting bracket, as
shown in Fig.13.
17
PSEN op 2/4 Series
Fig.12
Fig.13