Olimpia splendid CALDO TRENDY ST Mode D'emploi Et D'entretien page 30

3.4.e - "TIMER" mode
This mode can be used to activate a switching on/off timer of the appliance.
To activate the appliance SWITCHING ON timer, work as described below:
a. With the appliance in stand-by mode (with the power plug connected), press key
SW5 or T5 and choose the desired time value
(0h (Timer off) ---> 1h ---> 2h ---> .. 10h ---> 11h ---> 12h --->
b. The desired value flashes on the screen for a few seconds, then the display returns
to stand-by mode. The LED S6 remains steady on.
c. The appliance will switch on automatically when it reaches the previously set time.
To activate the appliance SWITCHING OFF timer, work as described below:
a. With the appliance on (Led S5 active), press key SW5 or T5 and choose the desired
time value
(0h (Timer off) ---> 1h ---> 2h ---> .. 10h ---> 11h ---> 12h --->
b. The desired value flashes on the screen for a few seconds, then the display returns
to show the detected ambient temperature. The LED S6 remains steady on.
c. The appliance will switch off automatically when it reaches the previously set time.
3.4.f - "SWING" mode
Press key (SW6) or (T6) until the LED (S4) switches on and the appliance body (1)
starts to rotate in alternate direction (fig.7).
Press key (SW6) or (T6) again: the function switches off and the appliance stops in
the chosen position.
4 - OVERHEAT PROTECTION
• This heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating. In this case:
- unplug the appliance;
- wait about 30 minutes for it to cool;
- remove any possible cause of overheating, eg. something covering the heater;
- check for damage to the appliance, the cord and the plug.
• If there is no damage:
- plug the unit back in;
- switch it on as described above.
If the heater still does not turn on, please contact Customer Service for assistance.
EN - 12
.. 0h (Timer off) ---> ..).
.. 0h (Timer off) ---> ..).