Olimpia splendid CALDO TRENDY ST Mode D'emploi Et D'entretien page 29

3.3 - USE OF THE APPLIANCE
3.3.a - Preliminary operations
• After installing the appliance as described in the previous para-
graphs, make sure the mains data correspond to what is indicated
on the appliance nameplate.
• Insert the plug into the power socket and position the switch (9)
to "I".
3.4 - INSTRUCTIONS FOR OPERATION
3.4.a - Switching on
Make sure the switch is set to "I" (ON) (6); press the ON/OFF key (SW1) or (T1): the
appliance emits a "Beep" and switches on.
Press the ON/OFF key (SW1) or (T1) again to switch off the appliance.
After the appliance has been switched off, the fan will continue to work for
approximately 1 minute to cool down the components, it will stop automatically.
Set the switch to "0" (ON) (6) to switch off the appliance.
3.4.b - "HIGH" mode
Press the Mode key (SW2) or (T2) until the Led (S1) switches on.
Press the keys (SW3 - SW4) or (T3 - T4) to increase or decrease the desired tem-
perature.
Temperature is read by a thermostat located in the appliance, install a ther-
mometer in another part of the room for a more accurate reading.
3.4.c - "LOW" mode
Press the Mode key (SW2) or (T2) until the Led (S2) switches on.
Press the keys (SW3 - SW4) or (T3 - T4) to increase or decrease the desired tem-
perature.
Temperature is read by a thermostat located in the appliance, install a ther-
mometer in another part of the room for a more accurate reading.
3.4.d - "ECO" mode
Press the Mode key (SW2) or (T2) until the Led (S3) switches on.
The appliance operates and adjusts power between 1000W and 2000W automatically
to maintain ambient temperature at 20° C.
CALDO TRENDY ST EN - 11