S&P TD-1300/250N Manuel D'instructions page 11

ENGLISH
This instruction manual contains important infor-
mation and must be read carefully by competent
persons prior to any handling, transport, inspec-
tion or installation of this product. Every care has
been taken in the preparation of the instructions
and information; however, it is the responsibili-
ty of the installer to ensure the system complies
with relevant national and international regula-
tions, especially safety. The manufacturer, Soler
& Palau Sistemas de Ventilación S.L.U. accepts
no responsibility for breakages, accidents or any
inconvenience caused by failure to comply with
the instructions contained in this manual.
The fans referred to in this manual have been
manufactured in accordance with rigorous qual-
ity control and International standard ISO 9001.
Once the product has been installed, this manual
to be retained by the end user.
WARNINGS
Any work including transport, installation, in-
spection, maintenance, service spares replace-
ment, repair and fi nal end of life disposal must
be carried out by competent persons and super-
vised by competent executive.
Fan equipment should be electrically isolated
and locked out before any work started.
This fan must not be used in hazardous area.
The Installer, User is responsible for ensuring
that the fan is installed, operated and serviced
by qualifi ed personnel, acting in accordance with
all safety precautions applicable and as required
by law, regulations and standards in the country
applicable.
Safety protective clothing, equipment, hearing
protection, and tools may be required.
All fans are designed and manufactured in ac-
cordance with EC Directive. Safety guard acces-
sories are available from S&P if required due to
specifi c installation.
This instruction manual is subject to modifi ca-
tions due to further technical developments of
the fan described, images and drawings may be
simplifi ed representations. Due to improvements
and modifi cations the fan operated may differ
from the representations. We reserve the right to
vary the product without prior notice.
Working ambient temperature for fan equipment
should not be exceeded, typically this will be
within -20°C to +40°C, unless stated otherwise.
Allow safe access to fan for inspection, mainte-
nance, replacement of parts, cleaning / house-
keeping.
The user is responsible for effective mainte-
nance, replacement of parts, cleaning, especially
where dust may form inside the fan.
Do not remove safety protection guards or open
access doors when the fan is in operation.
If the fan is used in atmospheres with more than
95% Relative Humidity (RH), consult the S&P
Technical Service fi rst.
Precautions must be taken to avoid the back-fl ow
of gases into the room from the open fl ue of gas
or other fuel-burning appliances.
The following risks have been identifi ed for con-
sideration:
• Installation: incorrect installation or function
represents a risk to safety.
• Rotational speed: identifi ed on fan name plate
and motor. Never exceed this speed.
• Rotation of impeller: identifi ed on fan with di-
rection arrows. Do not run impeller in reverse.
• Working temperature: identifi ed on fan name-
plate and motor. Never exceed this range.
• Foreign bodies: ensure no risk from debris, or
material that could be drawn into fan.
• Electrical risks: motor name plate data should
never be exceeded, effective connection to
earth, and all checked regularly every 6 months.
• Protection devices: These should always be op-
erational and never disconnected.
• Means for disconnection must be incorporat-
ed in the fi xed wiring according with the wiring
rules. An external disconnecting device, which
will function as the "designated" disconnect de-
vice must be provided, and:
1) It shall disconnect the "Line", while discon-
nection of the "Neutral" is optional;
2) Its OFF-position shall be clearly marked;
3) Not to position the equipment so that it is dif-
fi cult to operate it; and
4) The protection current device must be at
least 10A, 250V, curve Type C.
EN
11