EUROM 333893 Manuel D'utilisation page 27

3. Suspension from a ceiling by means of chains

Choose 2 suspension points in the ceiling, 40 cm
apart. Ascertain that the ceiling and fastening
materials are strong enough and suitable to take the
weight of the heater for an extended period of time.

Fasten the suspension eyes to the ceiling (not
supplied).

Hook one end of the chains onto suspension points of
the heater by means of the karabiner hook. You hook
the karabiner hooks at the other end of the chain
through the suspension eyes in the ceiling. Pulling
the chain through the suspension eye and fastening the second karabiner hook to
the chain allows you to raise the suspension height of the heater (see picture).
Please always take account of the minimum distances to the ceiling, floor, walls
and objects!
The following applies for all options

However you install the Golden Ultra, always lead the electrical cable directly
away from the heater. It may not become hot!

Adjust the desire radiation angle of the device. Do this by undoing both Allen
screws slightly using the Allen key. Make sure you secure them again once you
have made the adjustments! The heater can rotate through approximately 90° -
with wall fastening from 30° upwards to approximately 60° downwards. When
adjusting the angle ensure that the radiator does not radiate heat onto
flammable materials from a short distance!

Fasten all screws another time firmly and scheck or the heater is firmly mounted.
Now your infra red heater is ready for use.

For personal protection the installation, to which the Eurom Golden Ultra is
connected, has to be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between
the heater and the main supply, and to operate the heater with a switch. Because
the Eurom Golden Ultra has a high water tightness (IP65) and for safety reasons,
such a connection has to be made by a qualified electrician.
Working
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
When you use the appliance for the first time (or after a long time again), observe
it during the first 10 till 15 minutes to be sure that is works trouble-free.
27