EUROM 333893 Manuel D'utilisation page 25

The Eurom Golden Ultra infrared heater consists of:
1. Heater with suspension bracket, electrical
cable and plug
2. Wall bracket (2x) with short wing nut for fastening
3. Three brackets (various sizes) for suspension to tent frame, parasol or similar
item, with two wing nuts
4. A set of chains with 2x2 karabiner hooks for ceiling suspension
5. The remote control (RCD-type only)
6. fastening material.
The Eurom Golden Ultra has a separated electrical part with the receiving point for
the remote control and an on / off switch (7) on the side.
Installation
Before installing, secure the hanging bracket (9) to the heater. Using the Allen key,
undo the Allen screw (10) and pull the pin with the other screw out of the hole.
Place the hanging bracket (9) between both holes as indicated on the diagram.
Push the pin with the second screw back through the holes and the hanging
bracket. Then place the first Allen screw back and turn to secure using the Allen
key.
The Eurom Golden Ultra can be installed in three ways:
 Suspension from a wall (or possibly ceiling) by means of a wall bracket
 Suspension from a frame (parasol, tent or similar item) by means of a bracket
 Suspension from a ceiling by means of chains
Remove all package material (including the shock absorbing material around the
bulb) before installating the heater, keep the package material away from children.
Check the appliance, supply cord and the plug for signs of damage. Carefully
choose the right place to install your heater.
25