Eurosystems PN 120 Manuel D'utilisation Et D'entretien page 34

5.3. TOOL/ACCESSORY
UNCOUPLING [ fig. 09, 09A, 10 and 10A]
• Switch the machine's engine off.
• Make sure that the PTO lever [22] is
in the neutral
• Release the parking brake by mov-
ing the lever [25] into the position of
;
• Open the fixing hooks moving the le-
ver [26] into the position
• Exert pressure on the handlebars
from below upwards in such a way that
the front of the machine slides off the
tool.
5.4. HEIGHT ADJUSTMENT
CARE!
Never carry out adjustments with the
engine switched on. Always remove the
ignition key and/or the spark plug cap
before working on the accessory to pre-
vent sudden or unexpected starting.
CARE!
Always wear gloves and safety shoes
and use proper equipment when adju-
sting the working height.
It is possible to adjust the height of the
blade loosing the 4 nuts [21]. Moving the
slides [6] to the top or to the low positions
EN-10
position;
;
[ fig. 08]
until you get the requested height accor-
ding to the working needs. Then screw the
nuts back again [21].
5.5. INCLINATION ADJUSTMENT
[ fig. 08]
The snow blade can be laterally tilted by
30° both to left and right sides. In order
to change the position it is necessary to
press with the hand on the machine dri-
ving handlebar in order to lift the tool
from the ground and using the other hand
, press the tilt lever to the top side [14] to
disengage and rotate to left and or right
side until it locks in a side slot again.
5.6. PRELIMINARY CHECKS TO BE
MADE EACH TIME BEFORE STARTING
THE MACHINE
When the working day begins, before
starting the machine carry out the follow-
ing checks:
• Make sure all safety devices are wor-
king properly, check the status and the
condition of all protective guards and en-
sure they are in place.
DANGER!
If the check of the safety devices and
guards is negative, interrupt all the op-