Lift the accessory using a hoist or similar
tool with minimum capacity compatible
with the data indicated in the chapter
"Accessory specifications".
Hook as shown in
[15 , fig. 01]
4.4. HANDLING
Move the accessory only when attached
to the P130 machine.
If you have a van with crane equipped with
a lifting crane, follow the lifting instructions
indicated in the previous paragraph.
DANGER!
Never lift the accessory when attached
to the machine.
5. INSTRUCTIONS FOR USE
DANGER!
Before using the machine read and un-
derstand carefully this operation and
maintenance manual and the machine's
operation and maintenance manual.
5.1. FINISHING THE ASSEMBLING
Rotate the support
positioned perpendicular to the blade (4).
[ fig. 04]
Take the spring (15) from the loo-
se parts bag (13) and position it on the tilt
EN-8
(hooks).
[ 2, fig. 01]
until it is
lever (5) as shown.
[ fig. 05]
Enter the lever inside the two
brackets (22) on the blade (4) making sure
that the hook end of the spring (15) is ho-
oked as shown in the figure.
Add the screw (16) with washer (17) and
lock it with another washer and nut (18).
[ fig. 06]
Pull the spring (15) firmly until it
engages with the lever (5) as shown in the
figure.
[ fig. 09]
Complete the assembly by as-
sembling the tool on the machine as de-
scribed in point 5.2.
5.1.A. TIGHTENING OF THE
EXTENSION TUBE
[ fig. 07]
Insert the extension tube (14) into the
tilt adjustment tube (5) and lock it with
screw (23), washer (24) and nut (21). It is
possible to insert the whole pipe, fixing it
in the second hole (30), to occupy less
space in the storage.
5.1.B. BALLAST ASSEMBLY
Use the ballast to increase the contact
of the blade on the ground. Position the
ballast (8) on the blade (4) and fix it using
2 screws (19), the two washers (20) and
two nuts ( 21).
[ fig. 08]