Eurosystems SV 60 Manuel D'utilisation Et D'entretien page 31

off. Remove the spark plug cap or the
ignition key (if present) in order to avoid
unexpected starts.
The brush inclination setting can be varied
acting on lever [a] by varying the pin posi-
tion [b] shown in [ fig. 20]
The lever [a] allows to vary the direction
of the brush from 0° to +/- 90° while pin
[b] allows to vary the inclination from 0°
to 7,5°. Some possibile combinations are
shown in the [ fig. 21]
It is also possible to move the brush from
the left side to the right side with respect
to the forward direction by acting on the
lever [c] as shown in
The force and speed with which the brush
acts on the floor and / or on the working
surface can be adjusted using the wheel
lever [ fig. 11] and the engine accelerator
lever on the dashboard of the machine.
INFORMATION:
In order to reduce to the minimum the
brushes consumption and to prevent
wear of the floor, we always recommend
to start the work keeping the engine at
low revs and relieve the brush job by lift-
ing the adjustment wheel.
.
.
[ fig. 22] .
5.5 CLEANING
If the accessory / unit cleaning becomes
necessary during work (grass, dirt, mud,
etc.) switch off the engine and remove the
ignition key and / or the spark plug cap to
prevent unexpected starts.
DANGER!
Before entering the danger zone, wait for
all the machine's moving parts to come
to a stop (at least ten seconds from the
stopping of the engine).
DANGER!
Wait for the hot parts of the machine to
cool down (at least 15-20 minutes).
CARE!
Do not use pressurised water to wash the
machine and/or interchangeable equip-
ment. Doing so can damage the motor
and any electrical systems or batteries.
CARE!
Avoid excessive use of water near labels.
In the event of damage, labels must be
replaced before using the machine and/
or the interchangeable equipment again.
Use compressed air or a sponge with neu-
tral detergent and water
W
19