Eurosystems SV 60 Manuel D'utilisation Et D'entretien page 29

5.1 CONNECTION AND RELEASE
The interchangeable equipment, with or
without the brush, should be placed on the
ground resting on the stand so that the up-
per part of the frame should be parallel to
the ground [fig. 06]
and on the wheel [b] to adjust it correctly.
CAUTION!
At the first assembly the equipment is not
stable as it is laying on 2 points only (the
brush is not present). Help yourself with a
lifting equipment [a] and on the wheel [b]
to adjust it correctly
Then follow the instructions on the user's
manual for P130 unit.
CAUTION!
Before starting the machine, check if the
machine-accessory connection has been
carried out correctly by following the pro-
cedure below:
• When the engine is completely switched
off, press the bypass lever [a]
operate the clutch lever [b]
ing it in the operating position;
• Holding a hand on the bypass le-
ver [a] [fig. 08] slowly pull the engine
starter rope;
• The machine-accessory connection
will be active when, by slowly pulling
. Act on the stand [a]
[fig. 07] .
[fig. 08] and
, lock-
[fig. 08]
the cord, it will be possible to haul the
moving parts of the accessory.
INFORMATION:
During the a.m. operations a "CLACK"
sound can be heard when the pin on the
accessory falls inside the joint on the ma-
chine.
CAUTION!
Performing this procedure with the en-
gine running may damage the mechani-
cal parts of the PTO power take-off, com-
promising the operation of the power
transmission between the machine and
the accessory.
5.2 BRUSH ASSEMBLY
INFORMATION:
The brush body [b] is sold separetely.
In order to assemble the brush body on
the interchangeable equipment you need
this one to be correctly assemblied to the
unit [a] as shown in the picture
Brush assembly:
• Position the brush on a flat surface;
• Lift the wheel [ fig. 11]
front part of the machine;
• Remove the fixing pin of the brush
bracket [ fig. 12]
[fig. 10].
in order to lift the
and the automatic
17
W