Eurosystems SV 60 Manuel D'utilisation Et D'entretien page 30

brake [ fig. 13] .
• Link the the interchangeble equipment
to the machine and then position the
equipment on the brush.
• Lower the adjustment wheel driving
the grooved pin inside the hub
• Once the pin is completely inserted
inside the hub seat insert the fixing
pin of the brush
bracket [ fig. 13] .
CAUTION!
The fixing pin should be blocked by
securing it to the transmission shaft as
shown in [ fig. 15] . Possible damage to
mechanical parts.
Disassembly of the brush:
• Position the machine on a flat surface;
• Remove the fixing pin
• Raise the wheel
raise the front part of the machine.
• Move the machine by removing the
parking brake as shown in
5.3 PROTECTION CLOTH
DANGER!
The protective cover has to be assembled
before the first use of the unit and it should
be left assembled for all the work phases.
18
[ fig. 14] .
[ fig. 15] and brush
[fig. 15] ;
[fig. 15] in order to
[ fig. 13] .
DANGER!
The protective cover must be periodically
inspected and replaced in case of damage.
CAUTION!
The protective cover has to be adjusted
(istructions here following) whenever
there has been changes in the brush
settings (please see the chapter "SET-
TING OF THE BRUSH".
In order to assemble the cover please pro-
ceed as follows:
• Remove the handles and the fixing
screws friom the support [fig. 16];
• Insert the end of the 2 tubes inside the
guides on the interchangeable equip-
ment [fig. 17] .
• Insert the fixing screw and the washer
as shown in the picture
ing the whole with the handl.
The protection correct position is the one
shown in [fig. 19] where the front part is per-
pendicular to the driving direction of the ma-
chine and the lateral part is parallel. Please
always keep the mentioned orientation.
5.4 BRUSH ADJUSTMENT
CAUTION!
All the SETTING operations have to be
performed keeping the engine switched
[fig. 18] and fix-