Husqvarna MADSAW 525iDEPS Manuel D'utilisation page 16

To assemble the branch hook
• Use 2 screws to attach the branch hook.
To attach the harness support hook
• Attach the harness support hook on the
product with the spacer, the bolt, the nut
and the knob.
Introduction
WARNING:
understand the safety chapter
before you use the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
16
Operation
Read and
Only use Husqvarna
To adjust the harness
1. Put on the harness.
2. Attach the product to the harness support
hook.
3. Adjust the length of the harness until the
support hook is roughly level with your
right hip.
2. Push the battery into the battery holder of
the product. The battery locks into position
when you hear a click.
CAUTION:
does not move easily into the
battery holder, the battery is
not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed
correctly.
If the battery
1824 - 007 - 02.05.2023