Husqvarna MADSAW 525iDEPS Manuel D'utilisation page 22

To lubricate the shaft
Lubricate the ends of the drive shaft after
each 30 hours of operation. There is a risk
that the ends of the drive shaft (splined
coupling) wears if they are not lubricated
regularly.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
2. Lubricate the end of the drive shaft.
3. Assemble the shaft. Refer to
the shaft on page 14 .
To apply dielectric grease to the
shaft coupling
Apply dielectric grease to the inner surface of
the shaft coupling and the outer surface of the
shaft after each 30 hours of operation.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
2. Apply dielectric grease to the inner surface
of the shaft coupling and the outer surface
of the shaft.
3. Assemble the shaft. Refer to
the shaft on page 14 .
22
To check the chain drive sprocket
1. Regularly check the degree of wear on
To
To examine the cutting equipment
1. Make sure that there are no cracks in
To assemble
2. Make sure that the saw chain is easy to
3. Compare the saw chain with a new saw
4. Replace the saw chain when the longest
To
To do a check of the guide bar
1. Make sure that the oil channel is not
To assemble
the drive sprocket. Replace if wear is
excessive.
rivets and links and that no rivets are
loose. Replace if it is necessary.
bend. Replace the saw chain if it is rigid.
chain to examine if the rivets and links are
worn.
part of the cutting tooth is less than 4 mm/
0.16 in. Also replace the saw chain if there
are cracks on the cutters.
blocked. Clean if it is necessary.
1824 - 007 - 02.05.2023