Husqvarna MADSAW 525iDEPS Manuel D'utilisation page 21

Maintenance
Make sure that the battery is not
damaged.
Make sure that the battery is charg-
ed.
Make sure that the battery charger is
not damaged.
Examine all cables, couplings and
connections. Make sure that there is
no damage or dirt.
Clean the saw chain cover.
File off any burrs from the edges of
the bar.
Lubricate the shafts.
Apply dielectric grease to the shaft
coupling.
Do a check of the connections be-
tween the battery and the product.
Do a check of the connection be-
tween the battery and the battery
charger.
Do an inspection of the dielectric
shaft for worn and damaged areas.
Do not use the product if the die-
lectric shaft has worn or damaged
areas. Refer to OSHA 1910.269 for
more information.
Make sure that the saw head is not
damaged. Replace the saw head if it
is damaged.
Examine the wear of the chain drive
sprocket.
To examine the battery and the
battery charger
1. Examine the battery for damages, for
example cracks.
2. Examine the battery charger for damages,
for example cracks.
3. Make sure that the connection cord of the
battery charger is not damaged and that
there are no cracks in it.
1824 - 007 - 02.05.2023
Daily
X
X
X
X
An approved Husqvarna dealer must do all servicing on
Replace the chain drive sprocket after approximately
100 hours of operation or more frequently if it is neces-
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after
use.
2. Clean the battery and battery charger with
a dry cloth. Keep the battery guide tracks
clean.
3. Make sure that the terminals on the battery
and the battery charger are clean before
the battery is put in the battery charger or
the product.
Weekly
X
X
X
X
X
the saw head.
sary.
Monthly
X
21