Dräger Polytron 6100 EC WL Notice D'utilisation page 39

Symbol LED display Meaning
Red LED (gas A1 alarm (pre-alarm)
detector only) rap-
idly flashes once
Red LED (gas A2 alarm (main alarm)
detector only) rap-
idly flashes twice
Blue LED flashes
Bluetooth
once
Blue LED lights up
Bluetooth
continuously
mobile device
Yellow and blue Confirmation, internal battery counter reset
LEDs light up
4.2 Communication interfaces
®
4.2.1 Bluetooth interface
After the start sequence, the Bluetooth
activated.
If no connection is established, the gas detector disables the interface after 10
minutes (factory setting).
If the connection is to be secured with a pairing PIN, pairing can also be
performed and an individual pairing PIN assigned. The factory setting is the
connection without PIN.
An individual pairing PIN must be assigned for safety-related applications.
4.2.1.1 Activating the Bluetooth
®
● Activate the Bluetooth interface with a magnetic pen or via the
®
WirelessHART network:
Instructions for use |
Dräger Polytron
®
active
®
active, connected to Windows
®
interface of the gas detector is
®
interface
®
6100 EC WL, Dräger Polytron
● Magnetic pen: Tap the marking (Fig. A 12).
®
● WirelessHART : Activation via device description (DD) or device type
manager (DTM).
✓ The blue LED flashes.
4.2.1.2 Perform Bluetooth
®
The first time a Bluetooth
between the gas detector and the Windows
exchange characteristic data, meaning that they automatically recognize each
other the next time they are connected.
Prerequisite:
®
– Bluetooth interface on the gas detector and on the Windows
device is activated.
®
● If the Bluetooth pairing PIN "000000" is used, Bluetooth
automatic.
®
If an individual Bluetooth
appears for entering the PIN.
✓ After successful connection, the blue LED lights up continuously.
Gas detector and Windows
If required, use PolySoft to assign an individual Bluetooth
4.2.1.3 Establish Bluetooth
Prerequisite:
®
– Bluetooth interface on the gas detector and on the Windows
device is activated.
– A pairing was implemented between the gas detector and Windows
terminal device.
● Connect via PolySoft.
Entering a PIN is not necessary.
✓ After successful connection, the blue LED lights up continuously.
Gas detector and Windows
4.2.2 Connecting via WirelessHART
®
● Connect Windows terminal device to the respective management station of
®
the WirelessHART network.
®
Repeater WirelessHART
Operation
®
pairing and connect for the first time
connection is established, a pairing must be made
®
terminal device, i.e. both devices
®
®
-pairing PIN has been assigned, a prompt
®
terminal device with PolySoft are connected.
®
pairing PIN.
®
connection
®
terminal device with PolySoft are connected.
®
interface
®
| en
®
terminal
pairing is
®
terminal
®
39