Sonnenkonig VENTUS 200 Notice D'utilisation page 42

All manuals and user guides at all-guides.com
The heating element is
glowing
The appliance does not heat
up, only the ventilator works
Abnormal noise
The input voltage is too high
or too low
The air inlet grille is blocked
The switch was not turned to
set the heat
The thermostat is active
The self-resetting cut-out was
activated
The appliance does not stand
upright
42
Use power supply according to
the rating on the label
Keep the heater far away from
objects like curtains, plastic
bags, paper and other things
which can easily cover the air
inlet
Turn the switch to set the heat
Turn the thermostat and listen
if there is an open/close noise.
If there is no click and the
thermostat is not damaged,
the heater will automatically
switch on when the appliance
has cooled down.
Turn the heater off and inspect
the blockage of the inlet or
the outlet. Disconnect the plug
and wait at least 10 minutes
for the protection system to
reset before attempting to
restart the heater.
Put the heater on a level
surface