Télécharger Imprimer la page

Stalgast 803021 Notice D'instruction page 37

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
7. PROBLEMS, CAUSES, SOLUTIONS
Note: if the steps in the table below, aimed to remove the fault, did not produce the desired result,
contact your service (qualified technical personnel).
PROBLEM
The device does
not run
Excessive washing
duration
The appliance
does not wash
dishes
Stains on the
forks, glasses and
dishes
Dishwasher does
not rinse
Solenoid valve
leaking
The water pressu-
re in the appliance
is too low
The pump does
not pump out
water
8. MAINTENANCE
Before starting any maintenance work, disconnect the appliance from the power supply.
Daily maintenance involves removing objects from the chamber and washing them with a cloth dam-
pened in water with a dish detergent and then wiping them off with a dry cloth. Washing under running
water as well as using a pressure washer for this purpose is prohibited.
CAUSE
Appliance door does not close
Burnt fuse
Improper connection to the power grid
The temperature of the washing water is
not right
Abnormal level of water in the appliance
Broken washing pump
Low pump pressure
Water temperature is too low
Wrong detergent
Arms covered with limescale or foreign
bodies present
Empty detergent container
Malfunction in the water treatment unit
Improper arrangement of utensils
The temperature of the rinsing water is
too high
Incorrect water pressure
Water hardness too high
Cleaning agent did not work due to the
dirty water in the machine
Dishes drying improperly
Wrong rinse aid
Dirty water inlet filter
Low water pressure
Faulty rinsing pump
Contamination of the solenoid valve
Contaminated water inlet filter or solenoid
valve
Low water pressure in the water supply
Pump clogged
Faulty pump
Opening and re-closing the door
Replacing the fuse (call for
Check the electrical connection
Setting a suitable temperature
Clean the water inlet filter
Correct the water heating time
Clean the arms and remove fore-
Arrange utensils in accordance
Setting a suitable temperature
Change water in the appliance
Change water in the appliance
Clean the pump filter and soleno-
Call for service Note: When instal-
ling the appliance, foreign mate-
rial or undesirable chemicals from
the water supply could have been
trapped in the solenoid valve.
Clean the water inlet filter or
- 37 -
SOLUTION
service)
Call for service
Clean the pump filter
Contact manufacturer
ign bodies
Refill container
Notify service
with instructions
Clean filters
Check water hardness
Contact manufacturer
Clean the filter
id valve
Call for service
solenoid valve
Contact a plumber
Contact service

Publicité

loading