Stalgast 803021 Notice D'instruction page 33

2. Button functions
Rys. 6
Fig. 6
3. Starting the appliance
Activate the switch placed on the wall and press the On/Off (Fig. 7). Then open the hood of the dishwa-
sher, put the overflow plug in place (Fig. 6), put the basket into the chamber and select the program (Fig.
10). After closing the hood, the appliance will start filling its tank and the boiler with water - the boiler
pilot light will illuminate (Fig. 9). Once the water in the boiler is heated up, the dishwasher chamber
starts heating up the water - a pilot light of the heater compartment light will illuminate (Fig. 9). The
washing cycle will start automatically - the indicator light will illuminate (Fig. 8). If you open the door
during the wash cycle, the program stops automatically. After closing the door, the program continues
the wash cycle. After completing the program, the wash cycle indicator light turns off (Figure 8). Remo-
ve the basket from the chamber of the appliance. Note! Each operation that involves closing the hood
starts a new dishwashing cycle.
4. Emptying the tank in models equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance,
remove the overflow plug (fig. 6) and close the hood. The drainage process begins automatically and
continues until the tank is completely emptied of water. In order to activate the appliance place the
overflow plug back in its place, close the hood of the appliance, and then press the power button. Ho-
wever, if the appliance is not already in use, turn off the main switch.
5. Emptying the tank in models not equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance,
remove the overflow plug (fig. 6) and wait until the water leaks from the tank completely. Place the
overflow plug back in its place, close the hood of the appliance.
In the event of ending work with the appliance, after performing the above, it is mandatory to swi-
tch off the device by pressing the switch and then turning off the main switch and close the water tap.
6.4. Washing procedures (803035, 803036, 803037)
1. Control panel
Rys. 7 Rys. 8
Fig. 7 Fig. 8
Włącz/Wyłącz Cykl mycia
On/Off Wash cycle
Fig. 9
Rys. 9
Indicator light
Lampka
for chamber and
kontrolna pracy
boiler heaters
grzałki komory /
bojlera
- 33 -
Fig. 10
Rys. 10
Selecting program
Wybór programu
2-120 sek. / 3 -180 sek.
2 - 120 sec. / 3 - 180 sec.