Stalgast 803021 Notice D'instruction page 34

2. Button functions
Start button
Set button
Down arrow
Up arrow
Stop button
3. Displays
19
9 22
4. Parameter setting
After the first pressing of
tory-set password.
a. programming of temperatures and times
CUSTOMER SETTINGS
SET
Press
sing temperature (70-95 °C)
The
SET
Press
temperature (40-70 °C).
The
• turns the device on
• Pressing the button with the door open, launches the STOP
• confirmation of the introduced input data, setting of the
SET
• access to data setting: P1, P2, P3, P4, P5, P6
• reduces the washing or rinsing temperature
• drain pump (optional)
• increases the washing or rinsing temperature and increases
• turns the device off (does not disconnect the device from po-
display 1 – indicates the rinsing and sanitization temperature; washing cycle
display 2 – indicates the washing temperature
SET
arrows to change the data on display 2 into:
again. The displays will show the following data:
arrows can be used to adjust the temperature on display 2.
again. The displays will show the following data:
arrows can be used to adjust the temperature on display 2.
function. You can then close the door without starting the wa-
shing cycle. To turn the function off, press the button again
password
the duration of the wash or rinse cycle. C1-90 sec. C2-120
sec. C3-180 sec.
wer supply, the complete disconnection of the device occurs
after the plug is removed from the socket or the main external
switch is turned off), stops the washing and rinsing process
length C1 – C2 – C3
the display will show
- 34 -
. Use the
. This is the fac-
- sanitization-rin-
- washing water