Stalgast 803021 Notice D'instruction page 35

SERVICE SETTINGS (it is recommended that they are not changed)
SET
Press again. The displays will show the following data:
zation temperature (50-90 °C).
The
SET
Press again. The displays will show the following data:
release after the activation of the pressure switch (0-40 sec.) determining the water level.
The
SET
Press again. The displays will show the following data :
(8-15 sec.).
The
During the setting of the above parameters the display screen is blinking, and the values of the para-
meters can be changed using the arrows.
Function
Name
P1
P2
P3
P4 time for water release after the activation of the pressure switch
P5
b. programming of cycle duration
Press Display 1 will indicate:
– the set time is 90 seconds
– the set time is 120 seconds;
– the set time is 180 seconds;
The program is exited automatically 5 seconds after the selection of the desired cycle duration
3. Table of errors
Error code
EP 1
EP 2
E1 LO temperature of probe T1 is too low (below 0 °C) (or an open circuit in the probe)
E1 HI temperature of probe T1 is too high (above 110 °C) (or a short circuit in the probe)
arrows can be used to adjust the temperature on display 2.
arrows can be used to adjust the time of water release on display 2.
arrows can be used to adjust the sanitization time on display 2.
RECOMMENDED SETTINGS
Function description
sanitization (rinsing) temperature
washing temperature
minimal sanitization temperature
sanitization (rinsing) time
Error description
filling time exceeded, but a second attempt was undertaken
double filling time exceeded, attempts terminated
- 35 -
- minimal saniti-
time for water
- sanitization time
Recommended
value
90 °C
60 °C
82 °C
0 seconds
15 seconds