Stalgast 803021 Notice D'instruction page 31

4.6. First start-up
Before starting the appliance, check the correct operation of the electronic safety system. The
above steps and the first start-up may only be done by technical service personnel, who will also
conduct a short training in the operation of the appliance Each appliance is equipped with an adjustable
rinse aid dispenser. In contrast, the adjustable washing liquid dispenser is only supplied with some
models. A container for the washing liquid and rinse aid must be put in place and then connected to
suction tubes: the transparent one to the washing liquid, and the blue one to the rinse aid. To adjust, use
the adjustment screws shown in (Fig. 4). It is recommended that adjustments be made by the staff of
the company providing the rinse aid and washing liquid. Before connecting the suction tubes, weights
should be attached (to keep the tube at the bottom of the container) and filters should be installed (Fig.
5).
In the case where the two liquid dispensers have not been installed before installing the device, it
can later be done only by qualified technical personnel (technical service). Alternatively, an external
washing liquid dispenser can be connected through an electrical connection via a 2x0.5mm
cable. The cable must be connected through the passage indicated in the technical data diagram, in
accordance with the electrical parameters of the appliance and with the laws and regulations in force.
Dispenser parameters: 230V/50Hz, 15W. The washing liquid dispenser is connected to the dishwasher
through a transparent tube.
5. OHS RULES
In order to prevent burns and electrical shock, observe the following safety rules. To do this:
• train staff in the use of the appliance in accordance with the information contained in this manual;
• train staff in basic principles of using electrical equipment, safety at work and first aid in case of an
emergency;
• before starting any maintenance work, disconnect the appliance from the power supply,
• prohibit the use of the appliance, if any heating and/or control element has been damaged;
• do not wash under running water.
• only allow qualified technical personnel (technical service) to repair and/or inspect the appliance.
The manufacturer is not liable for any injuries or damage to the product resulting from failure to com-
ply with the recommendations contained in the instruction manual, improper use of the device, use of
non-original spare parts and attempts to repair the device independently.
• The device should be connected to an electrical grid with grounding in accordance with the applica-
ble regulations and standards.
• The device complies with the standards introduced under the European Union's Directives. The
proper storage of the device is an element of prevention of the pollution of the environment.
Do not add solvents to the dishwasher, such as e.g. alcohol, turpentine, as they could cause an
explosion. Also avoid placing dishes with left-over food inside the dishwasher.
The dishwasher and its components should not be used as a ladder or support for other applian-
ces or objects.
Do not sit on or lean against the components of the dishwasher, as this could cause an accident.
The water remaining on the dishes after completion of the cycle is not suitable for drinking.
Fig. 4 Fig. 5
- 31 -
2
H07 RN-F