Publicité
1. Jumper cable positive lead
2. Jumper cable negative lead
1. Câble de démarrage positif
1. Cable auxiliar positivo
2. Câble de démarrage négatif
2. Cable auxiliar negativo
Starting a warm engine
To start a warm engine, refer to the "Starting a cold
engine" section. The starter (choke) should not be
used. Press the accelerator pedal slightly.
Jump-starting
Jump-starting the vehicle should be avoided. The
battery should be removed and charged instead.
(See pages 8-107–8-111 for battery removal and
installation procedures.) However, if the vehicle
must be jump-started, proceed as follows.
1. Turn the key to "OFF".
2. Open the hood. (See pages 8-17–8-19 for
hood opening and closing procedures.)
3. Remove the battery compartment cover.
4. Using a charged 12 V battery, connect the
positive lead of the jumper cable to the posi-
tive terminal of the battery in the vehicle and
the other end of the positive lead to the posi-
tive terminal of the charged battery.
6-9
EVU00550
EVU00560
Publicité
