Publicité
Les langues disponibles
Les langues disponibles
Type 8645
EXPANDING A VALVE TERMINAL
Fig. 19:
Attaching more modules
Fig. 20:
Attaching the locking bracket
Fig. 21:
Valve terminal ready for use
All manuals and user guides at all-guides.com
Step 5:
→
The depression of the locking pins can be facili-
tated by pressing the module onto the existing valve
terminal.
→
Step 6:
→
Ensure that the connecting bracket is inserted neatly
into the guides and is pushed down parallel.
→
Step 7:
→
→
The valve terminal is ready for use again.
Remember that any address setting on the head
module must be adjusted to the original state.
→
Connect added modules to the existing valve
terminal by pressing and then turning the three
locking pins clockwise through 90°.
The slot is vertical.
Push the blue locking bracket over the desig-
nated guides.
To do this, support the bracket by gripping both
lugs and push all the way down.
E-rails must be re-attached.
Connect additional modules accordingly to the
FE contact.
To do this, open the window on the corre-
sponding head module and, using the rotary
encoding switch, set the corresponding bus
address.
english
13
Publicité
