American Standard 7441381 Manuel De L'utilisateur page 5

4
ELECTRICAL CONNECTIONS - SENSOR TO SOLENOID
• Connect SOLENOID CONNECTOR (12)
with the SENSOR CONNECTOR (2) from
the faucet.
Use Qty. (4) AA Alkaline type
NOTE:
batteries only.
5
ELECTRICAL CONNECTIONS – BATTERY HOLDER
• Identify desired BATTERY HOLDER (7) location.
Battery holder should be located so batteries can
be easily accessed, with in 6ft of the faucet hook
and loop (BLACK STRIP) (5).
• Attach 'hook to loop' fastener (BLACK STRIP) (5)
to the back side of the BATTERY HOLDER (7) and
attach 'hook to loop' fastener (BLACK STRIP) (5)
on desired location inside the kitchen cabinet. Wipe
mounting surface clean before attaching 'hook to
loop' fastener (BLACK STRIP) (5).
• Ensure that the BYPASS KNOB (10) on the
SOLENOID ASSEMBLY (1) is in the "OFF"
position.
• Connect the BATTERY HOLDER CABLE (9) to the
other end of the long SENSOR CABLE (6), that is
coming out of the faucet. Use the provided
extension cable if necessary. The sensor will
start to blink several times and then stop.
2
12
2
1
9
5
7
6
10