Publicité
Les langues disponibles
Les langues disponibles
FILLING THE SOLUTION TANK
1
Open the Solution Tank Fill Cover (2).
2
Read the dilution instructions on the chemical container. Then fi gure the proper amount of chemical to mix with 40 gallons (151 liters) of water.
3
Pour the proper amount of chemical into the solution tank and fi ll the tank with warm water to 7.62cm (3 inches) from the top of the tank opening.
4
Close the Solution Tank Fill Cover (2).
NOTE: If your machine was factory equipped with a chemical system you DO NOT mix chemical in the solution tank.
CAUTION!
Use low-sudsing, liquid detergents designed for carpet extraction. Water temperature should not exceed 130 degrees
Fahrenheit (54.4 degrees Celsius).
BEFORE USING THE AQUARIDE
Thorough vacuuming of the carpet to be cleaned is not necessary before using the AquaRide
sweeping broom and debris hopper.
PRE-SPRAYING THE CARPET
Pre-spray spots and heavy traffi c areas before extracting. Use a hand-held bottle sprayer or a pressurized "Hudson" type sprayer. Mix the pre-spray
according to the chemical manufacturer's directions.
PLAN FOR CLEANING
Before you begin extracting, look at the area to be cleaned and plan your work. Divide the space into sections. Overlap each pass 2 inches (5 cm).
All manuals and user guides at all-guides.com
SE / BRX 700
™
FORM NO. 56041541 - AquaRide
ENGLISH / A-7
SE or BRX 700 automatic extractors, due to the on-board
™
SE, AquaRide
SE AXP / BRX 700 series - A-7
™
™
Publicité
