Manual Mode - TERMA SKT 1 Mode D'emploi

be lower than the temperature of the remaining parts of the radia-
tor — this is a normal phenomenon.
Turning the device on does not mean that it uses the same maximum
power for the whole time it is on. On turning the device on, it op-
erates with the nominal power for a short period of time in order
to heat up the radiator to the set temperature. After that it turns
itself on and off periodically, using only as much energy as it is re-
quired to maintain the set temperature of the radiator for current
external conditions.

Manual mode

Manually set operating temperature is continuously maintained
until the next change of parameters or until start any of the au-
tomatic functions.
Dryer mode
The Dryer Mode allows to switch on the device for a set period of
time i.e. to dry a towel. When the time is out, the heating element
returns to its former settings mode.
In order to activate the dryer mode, press the
grammable dryer time is preset at 0,5 h. Each following press on
the extends the working time by additional 0,5 h, up to maximum
of 4 hours (pressing the button again ends the dryer mode and the
display shows the clock icon)
54
User Manual — Electric heating elements of the SKT series
In the dryer mode, the heating temperature can be adjusted — the
last temperature used in the dryer mode is memorised by the de-
vice. Any future start-up of the dryer mode will start operating with
the last memorised temperature.
The small numerical display shows a countdown clock telling, how
much time is left until the dryer mode ends. The large numerical dis-
play shows the temperature. Initially — the temperature set and af-
ter a short while — the actual temperature. (In order to see the set
temperature, please press one of the arrows on the display). After
dryer mode time runs out, the device returns to its former working
mode (If the device was off before the dryer mode was started, the
whole device will be switched off).
The dryer mode can be ended at any time with:
• the button — only the dryer mode will end — press the clock
button until the display shows 0 h,
• the button — the whole device will be switched off.
Clock
Current time (hh:mm) is displayed both when the device is on and
. The shortest pro-
when it is off with an exception of the dryer activation time or when
the device is being programmed.