Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting 1
Setting 2
Setting 3
TIMER mode
TIMER Mode is activated by pressing the button
turns on).
1.
TIMER Mode can be used to TURN OFF the device:
Press button
while the device is on — the device will turn
off after 2 hours.
2.
TIMER Mode can also be used to TURN the device ON:
Turn the device off using the button
the device will turn on after 2 hours, with the same tempera-
ture it was set to prior to being turned off. If the required tem-
perature is different to the one from before when the device
was turned off, set the required temperature before turning the
device off.
TIMER Mode can be turned off in at any time by pressing button.
ANTI-FREEZE function
When the device is off or in the TIMER mode but still has a live
feed, and the temperature inside the room falls down below 6°C
Setting 4
Setting 5
the device will automatically turn on and start heating. This function
will prevent the heating medium inside the radiator from freezing.
Yellow diode is flashing until the temperature reaches 6°C.
(yellow diode
FIL-PILOTE INTERFACE
Selected versions of SKT-2 are equipped with a FIL PILOTE in-
terface which enables remote heating control through an exter-
nal controller which conforms with
Signal
, press the button
—
User Manual — Electric heating elements of the SKT series
FP Command
Reaction of the Controller
Heating in accordance with current
FP-COMFORT
setting
Reduction of settings by 1 level (if
current setting equals 1, device will turn
FP-ECO
itself off)
FP-AF
No heating, anti-freeze function is active
Heating mode and anti-freeze functions
FP-STOP
are both off
51
Publicité
Table des Matières
