TERMA SKT 1 Mode D'emploi page 55

Clock programming
Press both arrow buttons at the same
time
Hour field will start flashing
Set the required hour using
Confirm it by pressing .
Minute field is flashing
Set the required minutes using and
confirm it by pressing .
Set time is displayed.
Clock programming is finished.
In case of a power cut, the device memorises last displayed time. If
the hour shown on the display flashes, it may mean that the time
shown is incorrect. Confirm the time by pressing any button or re-
set the time.
24-Hour timer
24-hour Timer enables specification of 4 different time zones (T1,
T2, T3 and T4), which allow different temperature settings and, in-
cluding periods when the device is switched off.
and
The start of every time zone is programmed subsequently from T1,
T2, T3 to T4 (hour and minutes), and the temperature for every time
zone is specified. The entire cycle is repeated every day on condi-
tion that the device is on and Timer is active.
Turning the device off does not delete the Timer settings. After turn-
ing the device back on with the
ed with the clock settings from before the device was turned off.
In order to deactivate the Timer press the
the arrows to set the Timer to OF and press
switch to the Manual Mode).
User Manual — Electric heating elements of the SKT series
button the Timer will be activat-
button for a while, use
again (the device will
55