Publicité
7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES
7-6. Setting start backtacking (856A, 855A-A0 [ ] only)
After thread trimming (or after the treadle has been depressed backward for the 855A-A0 [ ]), you can sew a set
number of stitches to create start backtack stitches.
1349M
t
y
u
Number of
Number of
stitches for
stitches for
section A
section B
93
All manuals and user guides at all-guides.com
<Example>
q
(2 stitches)
w
(6 stitches)
<When the condense dial is set to
a "-" (minus) value>
(2 stitches)
(6 stitches)
r
e
1447M
ZE-855A,856A
1444M
The stitch length for section A is
adjusted by means of the feed
adjustment dial q, and the stitch
length for section B is adjusted by
means of the condense dial w.
<When number of stitches for
section A is "00">
1445M
After thread trimming (or after the treadle has been de-
pressed backward for the 855A-A0 [ ]), make the following
settings.
1. Press the start backtack key e.
• The indicator r will illuminate and the start
backtacking function will turn on.
• The AB indicator t will illuminate and the number
of start backtack stitches will appear in the LED dis-
play y. (For example,
section A and 6 stitches for section B.)
selection keys u to change the number
2. Use the
of start backtack stitches.
3. Depress the treadle to start sewing the start backtack
stitches.
After this, stitches will be sewn at the pitch set by the
feed adjustment dial.
Note:
•
The sewing machine will continue operating until the
set number of start backtack stitches has been sewn,
even if the treadle is returned to the neutral position.
•
If the treadle is depressed backward, the needle will
stop in the needle up stop position at that point. (For
the 856A, the thread will be trimmed and then the
needle will stop in the needle up stop position.)
(If the zigzag stop position has been set, the needle
will stop in the set position.)
(6 stitches)
1446M
AA AA
indicates 2 stitches for
Publicité
