Anti Lock Brake System (Abs) - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

Adjustment method for VTR-Curve
Select VTR at setup item "M", Select setup item "R" and make the following adjustments:
1. Forward side adjustment:
EN
2. Use the (+) button to adjust the + side when you want to quicken the rise and use the (-) button to adjust
the side when you want to make the rise milder.
3. Curve switching point adjustment: When you want to change the curve switching point relative to the
throttle trigger, select the setting item „P" by ENTER button, and use the (+) and (-) buttons to move to
the point you want to set.
4. When ending setting, return to the initial screen by pressing the EXIT.
Adjustment Method for CUR Curve
Select CUR at setup item "M", select setup item "R" and make the following adjustments:
1. Curve setup: Select the setting item „1:" (1st point), by ENTER button and use the (+) and (-) buttons to
set the 1st point.
2. Set the throttle curve by sequentially setting „2:" (2nd point)~ „3:" (3th point).
3. When ending setting, return to the initial screen by pressing the EXIT. TERMS: M-MODE, R-RATE,BR-
BRAKE, VTR-VERTICAL, CUR-CURVES, P-TRIGGER POS, 1-3-Curves point 1-3.

Anti Lock Brake system (ABS)

When the brakes are applied while cornering with a 4 Wheel Drive or other type of vehicle, understeer may
occur. The generation of understeer can be eliminated and corners can be smoothly cleared by using this
function. When the brakes are applied, the throttle servo will pulse intermittently. This will have the same
effect as pumping the brakes in a full size car. The brake return amount, pulse cycle, and brake duty can be
adjusted. The region over which the ABS is effective can be set according to the steering operation.
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the ABS function and press ENTER.
3. Press ENTER to select PT item. Use +/- to change the value. Range: 0% - 100%
4. Press ENTER to select WD item. Use +/- to change the value. Range: 0% - 100%
5. Press ENTER to select CY item. Use +/- to change the value. Range: 0 - 30
6. Press ENTER to select DL item. Use +/- to change the value. Range: 0 - 100
7. Press ENTER to select DT item. Use +/- to change the value. Range: 0 - 100%
8. Press ENTER to select SM item. Use +/- to change the value. Range: 0 - 100%. If this value is 0, disable
the steering mix.
28
Neutral
linear
Neutral
TH.POS
forward side Quick backwards (BR: 0-100)
Operation
TH.POS
Neutral
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz