Model Memory (Model) - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

Operation
9. Press ENTER to select MODE item. Use +/- to change INH (OFF) or TH (ON),
10. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen.
EN
TERMS: PT-Operation: Throttle Trigger point
WD-Brake return amount: Sets the rate at which the servo returns versus trigger operation for brake
release. When set to 0%, the ABS function is not performed.
CY-Cycle speed: The smaller of the set value, the faster the pulse cycle.
DL-Delay amount: Sets the delay from brake operation to ABS operation. When set to 0%, the ABS function
is activated without any delay.
SM-Steering Mix
DT-Cycle duty ratio: Sets the proportion of the time of the brakes are applied and the time of the brakes are
released by pulse operation.
MODE: If it is selected to INH, the function disable. If it is selected to TH, the ABS function for THROTTLE
brake. When it is selected to AUX, the ABS function for the AUX channel. If it is selected to TH + AUX,
the ABS function for both THROTTLE and AUX.
NOTE: the AUX and TH + AUX can select only the Brake MIX set to ON.
without ABS with ABS

Model Memory (MODEL)

Press "ENTER" in the power on interface, and enter function menu interface. Press "+" or "-" to choose MDL,
and press "ENTER" to enter MODEL adjusting interface.
1. Press "ENTER" to choose "mod00".(SEL)
2. Press "+" or "-"to choose "mod00~mod15"
3. Press "EXIT"to save your setting and leave SEL interface, and back to the function menu interface.
Enter Model names:
1. Press "+" or "-"to choose "EDT".
2. Press "ENTER" to enter rename mode ,Press "+" or "-"to choose "0.1.2....I"
3. Press "ENTER" on the display to save your modified and return to the MODEL Screen..
4. Press "EXIT"to save your setting and leave EDT interface, and back to the function menu interface.
ENTER
Copy one memory to another:
1. Press "+" or "-"to choose "CPY".
29
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz