Transmitter Controls; The Remote Control System; Binding Process - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

Transmitter controls

EN
Antenna
LCD-Display
Power-Switch
Charging Jack
Programming
Buttons

The remote control system

Here you get an overview of the remote control system and its various features and settings. Before the first
flight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bottom of the transmitter and insert eight AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter. Pay attention to the correct
polarity!
• Close the battery compartment cover and turn on transmitter – push ON / OFF switch in position I.
• Connect and install the receiver and servos.
WARNING:
Be careful with the installation of the receiver. Never bend or shorten the coaxial antenna wire! The
actual „antenna" is the stripped end of the antenna wire and must be installed in the vehicle so far
above as possible. Avoid damages of the antenna cable!

Binding Process

1. Turn on the transmitter and receiver.
24
Batt. (4.8 - 6.0 V DC)
CH 3 = AUX
-
+
S
CH 2 = Throttle
CH 1 = Steering
Transmitter controls · Binding
AUX-Channel
Steering Trim
Steering Wheel
Throttle Trim
Throttle Trigger
Throttle Hold
Steering Dual Rate
Battery Box
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz