Failsafe (F/S); Neutral; Sound - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

Operation

Failsafe (F/S)

If the RF signal loss, it should occur the receiver adjust the Steering or Throttle or both to a preset
value. The servo value of Steering channel and Throttle channel in the fail status can be set through
fail safe function.
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the F/S function and press ENTER.
3. Press ENTER to select a item.
4. Use the +/- Key to change the value.
5. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main
Screen.
6. TERMS: ST: To set the servo value of Steering channel. Range -120% to +120%. Default: 0%.

Neutral

This function can calibrate the neutral of the STEERING wheel or THROTTLE trigger.
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the NEUTRAL function and press ENTER.
3. Use the +/- Keys to select YES.
4. Press ENTER to calibrate the neutral.
5. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen.
Note: Don't move the STEERING wheel or THROTTLE trigger in the calibrate procedure.

Sound

This function can open or close the buzzer sounding.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the SOUND function and press ENTER.
3. Use the +/- Keys to select INH or ACT.
4. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main
Screen.
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz
EN
33