Exponential Function Steering (St Curv); Throttle Curve (Th Curv) - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

Operation
the center becomes the opposite side.
TERMS: ST-STEERING, TH-THROTTLE,AUX-AUXILLIARY

Exponential function Steering (ST CURV)

This function is used to change the sensitivity of the steering servo around the neutral position. It has no effect on the
maximum servo travel. Note: When the setting is not determined, or the characteristics of the model are unknown,
start with 0% ( when EXP is set to 0%, servo movement is linear).
1. Press "ENTER" to see FUNCTION MENU.
2. Use the +/- Keys to select the ST CURV function and press ENTER.
3. Use the +/- Key to change the value.
4. Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen.
5. STEERING CURVER adjusting value range: -100%~+100% Default is 0% (Linear)
6. When you want to quicken steering operation, use the (+) button to adjust the „+" side. When you want
to make steering operation milder, use the (-) button to adjust the „-"side.
7. When ending setting, return to the function menu by pressing the (EXIT) button. TERMS: M-MODE, R--RATE

Throttle Curve (TH CURV)

This function makes the throttle high side and brake side direction servo operation quicker or milder. It has
no effect on the servo maximum operation amount. For the high side, selection from among three kinds of curves
(EXP/VTR/CUR) is also possible.
Note: When the course conditions are good and there is no sense of torque at the power unit, set each curve to
the + side (quick side). When the road surface is slippery and the drive wheels do not grip it, set each curve to
the - minus (mild) side. Note: Brake side only has EXP curves.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH CURV function and press ENTER.
3. Press ENTER to select a setting.
4. Use the +/- Key to change the value.
5. Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen.
Adjustment method for EXP curve
Select EXP at setup item "M", select setup item "R" and make the following adjustments:
1. Forward side adjustment:
Use the (+) button to adjust the + side when you want to quicken the rise and use the (-) button to adjust the -
side when you want to make the rise milder.
2. Brake side adjustment:
Select the setting item „BR" by ENTER button and use the (+) button to adjust the + side when you want to
quicker the rise and use the (-) button to adjust the - side when you want to make the rise milder.
3. When ending setting, return to the initial screen by pressing the EXIT.
Neutral
Quick forward (R: 0-100)
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz
Neutral
TH.POS
Mild forward (R: -100-0)
TH.POS
Neutral
mild backwards (BR: -100-0)
EN
27